Thermal Banks store heat between seasons | Seasonal Heat Storage | Rechargeable Heat Battery | Energy Storage | Thermogeology | UTES

ThermalBanks store heat between seasons

A Thermal Bank is a bank of earth used to store heat energy collected in the summer for use in winter to heat buildings. A Thermal Bank is an integral part of an Interseasonal Heat Transfer system invented, developed and patented by ICAX to answer the need for on site renewable energy without burning fossil fuels.

Interseasonal Thermal Store – Rechargeable Heat Battery

A Thermal Bank is used to store warm temperatures over a very large volume of earth for a period of months, as distinct from a standard heat store which can hold a high temperature for a short time in an insulated tank. A Thermal Bank acts as a rechargeable heat battery.

Heat moves slowly in the ground – Thermal Inertia

It is a characteristic of earth that heat only moves very slowly through it – as slowly as one metre a month. ICAX exploits this thermal inertia to input surplus heat into the ground over the summer months and extract that heat over the winter months for use in the space heating of buildings.

Interseasonal Heat Transfer works by capturing heat energy from the sun via a collection pipe network just beneath the surface of black tarmac roads (or car parks or school playgrounds). It then stores the energy in computer-controlled Thermal Banks in the ground under the foundation of buildings, and releases it to heat the buildings in winter via heat pumps linked to underfloor heating.

Constant temperature only if undisturbed

The temperature of the ground at a depth of six metres in the UK will normally be very close to 10°C – the temperature will vary very little between summer and winter as heat only moves very slowly in the ground. ICAX uses this characteristic of the ground to store heat from summer to winter. Using fluid – in an array of pipes – as the transport mechanism solves the difficulty of getting the heat into the ground – and out again.

The way in which heat is absorbed and released by the ground is complex and required to be studied using complex iterative methods that have only become practical with the use of computational fluid dynamics (“CFD”). The computer models developed by ICAX have since been tested in practical installations and refined to reflect empirical results. These have been used to refine the design parameters for successful ThermalBanks with an understanding of the Thermogeology involved.

Black surfaces absorb heat

Tarmac roads tend to absorb the heat of the sun up to the point when they radiate heat as quickly as they are absorbing it: the surface temperature of tarmac in full sunshine can often reach 15°C higher than the ambient air temperature.

ICAX collects heat using water circulating through an array of pipes embedded in the surface of the tarmac and deposits it in ThermalBanks constructed beneath the insulated foundation of buildings: solar recharge of the ground. The temperature across the ThermalBank can be increased from its natural temperature of 10°C to over 25°C in the course of the summer months.

ICAX uses a ground source heat pump to extract heat from the ThermalBank when it is needed to heat the building in winter using underfloor heating. Unlike a normal ground source heat pump which typically starts with an autumn ground temperature of 10°C the heat pump in an Interseasonal Heat Transfer system starts with a temperature of over 25°C from the ThermalBank.

IHT doubles the CoP by starting with warmth

This doubles the Coefficient of Performance of the heat pump and allows a 50% saving of carbon emissions compared to providing heat from a gas boiler.

Underground Thermal Energy Storage – UTES

A Thermalbank is also described as Underground Thermal Energy Storage - UTES, or as providing Seasonal Heat Storage because it can be used as a rechargeable heat battery.

Borehole Thermal Energy Storage – BTES

Where it is not practical to create a horizontal Thermalbank to store energy ICAX uses a borehole field to perform the same function. This is described as Borehole Thermal Energy Storage – BTES. Angled boreholes, also called an inclined boreholes, can be used if surface area is limited.

Thermal Bank

A Thermal Bank is a bank of earth used to store heat between seasons. Alternative descriptions include: Heat Bank, Heat Battery, Heat Store, Heat Vault, Underground Energy Storage, Seasonal Heat Storage, Interseasonal Heat Store, Seasonal Thermal Store, Interseasonal Thermal store, Underground Thermal Energy Storage ("UTES"), seasonal soil heat accumulator.

ThermalBanks™ store heat between seasons

and save carbon emissions
by re-cycling Renewable Heat through
Interseasonal Heat Stores

Seasonal Heat Storage